DAA Hi-Capacity Powder Hopper

Double the capacity of your Dillon Powder Measure quickly.
This 36cm powder hopper replaces the standard 18cm hopper in less than 5 minutes.
Also this powder hopper comes with an acrylic powder baffle which is essential to drop consistent powder charges.
The Dillon Powder Cap and the Low Powder Sensor can still be used, However you will need to extend or replace the sensor rod to adapt to the height of the new hopper. (Parts not included)

Dillon 1050: This Hopper does not fit under the case feeder of the 1050 by default, but you can shorten it on the top end by 9cm easily using a saw or serrated knife

Funktion:

• remove the remaianing powder from the powder measure completely
• remove the screws that secure the original hopper to the powder measure
• remove the original powder hopper.
• install the new large powder hopper
• install the screws to secure the new powder hopper to the powder measure
• optional: replace or extend the sensor rod of the Low Powder Sensor (Parts not included)